Blir du plaget av "Microsoft"? Eller andre som ringer og bare legger på?
After accidentally dropping my iPhone for a swim into a pool of water where it was fully submerged, I had the unfortunate opportunity to test out the iPhone-in-a-rice-bag hypothesis, and I have good news; it actually works!
Here is exactly what I did, and what I learned from the process of saving an iPhone from extensive water exposure with the good old rice bag trick. The result is a completely functioning iPhone with zero water damage.
Want to save your iPhone? Drop everything and do this first, before putting it in rice:
Now with all visible water removed, you’re ready to stuff the iPhone into a rice bag.
Here are the basic requirements:
Fill a zipper locked bag fairly full of rice so that the entire iPhone will be covered like in the picture below, then place the iPhone into the bag and seal it shut with some air in the bag.
Any type of rice works, but try to avoid enriched rice, the reason being that whatever enriches it leaves a lot of white residual powder in the bag and it will also get into the ports and buttons on the iPhone. Enriched rice does still work (it’s actually what I learned), but knowing now that it leaves a lot of mystery white powder gunked up in places, I’ll probably go buy a bag of normal rice for any potential future water-meets-iPhone encounters. The patience part is the hardest, and generally the longer you wait the better the likely outcome because you want all water inside the device to be completely absorbed by the rice before trying to power it on again. I left my iPhone in the air-tight rice bag for around 36 hours, but there’s no harm in leaving it in for 48 hours. Any less may work but it also could be inadequate, so therefore longer is better.
Once you’ve waited at least 36 hours, open the rice bag and check out the iPhone. If you suspect the iPhone has any residual moisture left in it at all, do not power it on. If all seems well, go ahead and turn it on as usual. If all goes well, it’ll power on as usual, and your iPhone will have survived the water encounter!
Here’s my iPhone turned on for the first time after a full submersion in water, it works beautifully just as normal, and is dry as can be:
This should work for almost every instance of severe water contact with an iPhone, though obviously for situations where an iPhone is soaking in water while turned on for 15 minutes or longer your likelihood of recovery is going to diminish dramatically. Likewise, you’ll have much better recovery odds with fresh water than you would with salt water, simply because salt water is more corrosive. Soft drinks and sticky beverages will be more challenging as well since they leave more residue around, but as long as it dries out it will probably survive even if you dump a coke or coffee onto an iPhone.
After the iPhone is dried out completely, check out the liquid contact indicators. Each iPhone is equipped with several water damage sensors that turn red if contact with any fluid is made, and if they are triggered than the likelihood of free repair service is fairly slim and your warranty may be toast. You can check these yourself by looking at the following locations, depending on your iPhone model (image via Apple):